Furman M-8DX Merit Series Power Conditioner With Light And Voltmeter

Install an M8X in to the top slot of your rack, and the eight switched outlets in the rear panel will power up and protect all your equipment up to a 15-amp load. One big spike and your rig is up in smoke. Furman's standard level surge/spike protection defends your gear from the spikes and surges that are so common at gigs and practice spots. With Furman's standard level RFI/EMI filtration, you'll get a quieter tone without pops, crackles, and the local radio station coming out of your amp. In addition when you are recording, you can't track down where that noise is coming from? Your mix is sounding flat? With Furman's standard level RFI/EMI filtration you'll lower the noise floor caused by the dirty AC power coming into your console or DAW. Furman's standard level surge and spike protection keeps your sensitive Digital equipment from acting funny or burning up due to everyday spikes and surges. With a 15A capacity and nine total outlets, it's enough to power your whole home studio! Plus the M-8Lx features two slide out, swiveling light fixtures to provide discreet illumination of your equipment on stages, in studios, and in other dark places. A dimmer knob lets you adjust the lamp brightness to just the right level. The M8DX also features a bright red, three-digit LED voltmeter that displays incoming voltage.

Maximum Output Current: 15 amps

Line Cord: 6 feet, captive, 14 AWG, with 3-conductor Edison plug

Operating Voltage: 120VAC 60Hz

Spike Protection Mode: Line to neutral

Energy Dissipation: 170 Joules

Peak Impulse Current: 12,000 amps

Maximum Continuous Operating Voltage: 130 VAC RMS

Let Through Voltage (@ 125 amps, 8/20uS waveform): 400 volts

Noise Attenuation: Transverse mode: Greater than 23dB, 200Khz to 10 MHz

Two slide out, swiveling light fixtures

Three-Digit LED Voltmeter That Displays Incoming Voltage

Dimensions: 1.75 H x 19 W x 7.5 D inches

Weight: 5.8 lbs.