Klipsch RSA-500 In-wall Subwoofer Amplifier

This high-powered device will drive up to two of any of these Subwoofer modules and delivers 300 Watts into an 8-ohm load (one subwoofer module) and 500 watts into a 4-ohm load (two subwoofer modules). It also comes with rack ears for fast and secure placement into any standard 19-inch rack. To keep end users from inadvertently tampering with performance levels, the majority of the RSA-500’s controls are housed on its rear panel. The fuse is also included on the back for quick and easy replacement. A detachable IEC power cord allows for the simple removal and reinstallation of the entire amplifier unit. The RSA-500 was also designed to “play nice" by offering standard input/output Connectivity that will support any type of system.

EQ Switch for use with different subwoofers

Selectable signal-sensing or voltage triggered auto-on/off circuit

300 watts continuous into 8 Ohms or 500 watts continuous into 4 ohms

Line and speaker level inputs

Rack ears included

Frequency response 20Hz-1kHz ± 3dB

Amplifier power FTC Rated Power: 300W into 8 ohms, 500W into 4 ohms, 20Hz-1kHz @ <1.5% THD Dynamic Power: 875W into 8 ohms

Low pass crossover Continuously variable from 40-120Hz,

Amplifier BASH Hybrid

Phase Switchable between 0 and 180 degrees

Enclosure type Use only with RW-5802, and AW-800-SW subwoofer enclosures (either one or two)

Inputs 2 Gold-plated speaker binding posts, 2 Gold-plated RCA phono jacks plus single LFE

Outputs 2 Gold-plated unfiltered RCA phono jacks plus single LFE

Auto power on 2 second ON delay, 15 minute OFF delay

Unit dimensions 3.5" (8.9cm) H x 17" (43.2cm) W x 12.6" (32cm) D (without rack ears); Weight 18 lbs. (8.2kg)